The inner tank of water treatment pressure tank is made of PE plastic, and the outer layer is wound by high-performance epoxy resin and reinforced fiber.
Polyethylene is a kind of high molecular organic compound, which can be divided into low density polyethylene, medium density polyethylene and high density polyethylene according to density.
The PE lining used in the pressure tank is high-density polyethylene, which is integrally formed by blow molding or roll molding. The tank body has no joints and no leakage.
The inner tank of water treatment pressure tank is made of PE plastic, which is not only non-toxic, tasteless and safe, but also resistant to most acids and alkalis (except oxidizing acids), high thermoplastic and good electrical insulation. In this state, it can still maintain a certain toughness.
The pressure of PE lined water treatment pressure tank is 125psi or 150psi, the working temperature is 1-49 ℃, the maximum vacuum degree is 127mmhg, and the minimum storage and transportation temperature is - 27 ℃.
PE lined water treatment pressure tank can be used for water treatment container of filter or water softening equipment. The equipment shall be installed indoors to avoid direct sunlight. During operation, pay attention to the daily maintenance of the tank.